Friday, April 2, 2010

Tail work

I'm back ... slowly.

I did some work on the rear tip of the vertical tail, namely on the elevator control linkage area. I added the PVC guides between the rear 1/4 x 0.035" tubes. Instead of just making a slurry of epoxy, I manufacturer a couple foam stand-offs to tie the guide tubes to the structural member. I 3M'd some 1" wide fiberglass tape around the foam, PVC, and aluminum tube, then I added some thickened epoxy to fillet the sharp intersection of the 1/4" tubes, then I 3M'd another glass wrap around the whole thing, on the outside of the fillet. I mashed epoxy into the fibers and thoroughly wet out enough to practically see through the fiberglass tape. A simple layer of peel-ply and clamps to ensure the fabric fit down in the fillets nicely, let cure overnight, and admire the handiwork. I'd say these aren't going ANYWHERE without some severe hammering. I remembered to add some shims/spacers inside the guide tubes while I was doing this bonding, so both guides are parallel and in good alignment. It's super smooth motion. Yes I couldn't resist putting the horizontal stab back on and seeing how the elevator stick felt ... 'bout the same as before.

While I had epoxy on the brain, I finished off the rudder ribs. I did two at once, pushing epoxy through the fibers of the 3M'd fiberglass tape, then using a wrap of peel-ply to get a nice finish. In the morning, I pulled off the peel-ply and knocked down the edges with an 80 grit sanding block. Two evenings' work, and the rudder is as good as done!

Oh I just checked the pictures of the elevator guides above. I guess I took the photo between layers. You can see the flox fillets around the 1/4" tube before putting the final wrap over them. Take my word for it, the next wrap actually went on rather well (3M is great stuff).

Locations of visitors to this page