Mega-axle!

The torsion axles are not going anywhere ever again.  The frame is going to bend before this axle dies.

Welding steel is so much more enjoyable than aluminum.  It took about three hours to work my way around all the open edges, but it wasn't that bad.  The arc is more stable and it seems like this is the way welding should be.  I must be doing something wrong with the aluminum setup.

The axle assembly is bolted back to the frame now.

I thought about going for a short drive around the neighborhood, but I've done this before.  One of the aluminum truss members has broken tack welds from yesterday's crash.  Without the ~200b of plywood being bolted back on, the trailer will ride light and bounce around.  I'll save the drive for another day.

Next up is liquid wet stuff.  Enamel paint for the axle.  Epoxy-coat for the plywood decking.  It'll be a few days in the garage, so I might not get to this for a while.

There are some repairs to do from the broken axle event last night.  The left trailer light rode on the asphalt and destroyed the wires and scraped away some plastic.  Ironically, I have a spare left light assembly if this one not repairable.  Some of the metal frame also scraped away and needs inspection.  It never ends.

Trailer to do's are now:

• weld axle assembly
• drill holes in axle assembly
• mount axle assembly
• paint axle assembly with some enamel paint
• repair left tail-light wiring
  
• figure out how Goat parts sit in the trailer
  
• take all of Goat for its first trip around the neighborhood
• buy more Argon gas
  
• finish weld the vertical elements
• add reflective tape on the sides
• install and wire running lights on the sides
• epoxy-coat seal the ply decking
  
• create a rear door that can be quick-pinned in place
• figure out front/side/back walls
  
• dream up a top lid

For the first-flight:

• backyard final assembly and thorough pre-flight check, including weight & balance
• re-weld the tow hitch release (I'm now doubtful it had good penetration) 
  
• buy tow rope, weak-links, and end rings
  
• buy/borrow radios (1x airborne, 1x car)
  
• find a place to fly
• travel
• fly

After the first-flight:

• add leather patch to wing tips where will rub the ground
• install leather patch guides for elevator control lines
• paint trim color
• install wing root kiss seal
• build a wing tip dolly
• build a wing wheel
• jury strut fairings
  
• main strut fairings (after flying to figure out the right angles)
• emergency parachute
  
• real variometer (LXNav with a TEK probe is my intention, if it is sensitive at low speed...)
• dogue chute